Single component acrylic waterproofing membrane
Vetoproof AM763 is a single component elastomeric water-based acrylic membrane that has versatile uses for waterproofing in residential and commercial construction. The product is available in a variety of colors.
Vetoproof AM763 supplied in 18 Kg Pails. Coverage 1.5 Kg/m2/coat.
Original sealed container of Vetoproof AM763 and has a shelf life of 12 months provided it is stored clear of ground in a dry shaded place below 35ºC.
Vetoproof AM763 can be applied by brush, roll, or airless spray machine. Porous surfaces should primed with vetoproof AM763 primer at the rate of 5 m²/liter and allowed to dry before applying the first coat. The first coat of Vetoproof AM763 should be applied at the rate of 1.5 - 2.0 m²/kg and allowed to cure for 4 - 12 hours depending on ambient temperature.
The second coat should be applied perpendicular to the first coat at the same rate above, and allowed to cure.
For heavy pedestrian traffic, it is recommended to use fiberglass scrim reinforcement, embedded firmly in the second coat while wet, and a third coat should be applied.
Vetoproof AM763 product should be removed from tools, equipment and mixers with clean water prior to the initial set. Cured material can only be removed mechanically.
All surfaces should be dry and free from contamination such as oil, grease, loose particles, decayed matter, moss algal growth, laitence, and all traces of mould release oils and curing compounds. This is best achieved by lightly grit-blasting the surface. Where moss, algae or similar growths have occurred, treatment with a proprietary biocide should be carried out after the grit-blasting process. Spalled and deeply disintegrated concrete should be removed to sound concrete and repaired with a Saveto repair system.
Concrete substrates should be at least 14 days old, bituminous substrates should be 3 to 6 months old prior to overcoating with Vetoproof AM763.
Vetoproof AM763 should not be applied at ambient temperatures below 5°C and dropping. Vetoproof AM763 should not be applied on surfaces expected to suffer form rising dampness or relative humidity greater than 75%.
Vetoproof AM763 contains acrylic polymer which can be harmful to the skin. During use, avoid contact with skin and eyes. Wear suitable protective clothing, gloves, eye protection and respiratory protective equipment. The use of barrier creams provide additional skin protection. In case of contact with skin, rinse with plenty of clean water, then cleanse with soap and water. In case of contact with eye, rinse immediately
with plenty of clean water and seek medical advice. If swallowed, seek medical attention immediately – do not induce vomiting.
Vetoproof AM763 is non-flammable.
Saveto endeavors to ensure that any advice, recommendations, information it may give, is accurate and correct. It cannot accept any liability either directly or indirectly arising from the use of its products, because it has no direct or continuous control over where or how its products are applied, whether or not in accordance with any advice, specification, recommendation or information given by us. Saveto has the right to change any of the specifications mentioned in the Technical data sheets upon its discretion without prior notification.
Hard copies of TDSs are printed once or twice a year, while our technical data sheets are continuously being updated as per R&D improvements and new 3rd party testing; kindly refer to our website for the latest updated TDSs.
Single component elastomeric crack-bridging cementitious waterproof membrane
Single component ultra flexible acrylic waterproofing membrane
Polymer modified water resistant cementitious top coat
Single component penetrating waterproofing system for concrete
Elastomeric crack-bridging cementitious waterproof membrane
Acrylic polymer modified decorative finish coat applied at thicknesses from 3 to 20 mm