Single component flexible pure acrylic waterproofing membrane
Vetoproof AM764 is a single component elastomeric water-based acrylic membrane that has versatile uses for waterproofing in residential and commercial construction. The product is extremely stable in extreme weather conditions. Vetoproof AM764 is an all-cross-linking-acrylic making it resistant to yellowing, color fading and has excellent dirt-pick up resistant.
Vetoproof AM764 supplied in 20kg Pails
Theoretical Coverage - 0.7 - 1.2 kg/ m2 / coat
Original sealed container of Vetoproof AM764 and has a shelf life of 12 months provided it is stored clear of ground in a dry shaded place below 35ºC.
Vetoproof AM764 can be applied by brush, roll, or airless spray machine. Porous cementitious surfaces should primed with Vetoprime AP443 at the rate of 5 m²/liter and allowed to dry before applying the first coat. The first coat of Vetoproof AM764 should be applied at the rate of 1.2-1.9 m2/kg and allow to cure for 4 - 12 hours depending on ambient temperature.
The second coat should be applied perpendicular to the first coat at the same rate above, and allow to cure.
For heavy pedestrian traffic, it is recommended to use fiberglass scrim reinforcement, embedded firmly in the second coat while wet, and a third coat should be applied.
Vetoproof AM764 product should be removed from tools, equipment and mixers with clean water prior to the initial set. Cured material can only be removed mechanically.
All surfaces should be dry and free from contamination such as oil, grease, loose particles, decayed matter, moss algal growth, laitance, and all traces of mould release oils and curing compounds. This is best achieved by lightly grit-blasting the surface. Where moss, algae or similar growths have occurred, treatment with a proprietary biocide should be carried out after the grit-blasting process. Spalled and deeply disintegrated concrete should be removed to sound concrete and repaired with a Saveto repair system. Concrete substrates should be at least 14 days old, bituminous substrates should be 3 to 6 months old prior to overcoating with Vetoproof AM764.
Vetoproof AM764 should not be applied at ambient temperatures below 5°C and dropping. Vetoproof AM764 should not be applied on surfaces expected to suffer from rising dampness or relative humidity greater than 75%.
Vetoproof AM764 contains acrylic polymer which can be harmful to the skin. During use, avoid contact with skin and eyes. Wear suitable protective clothing, gloves, eye protection and respiratory protective equipment. The use of barrier cream provides additional skin protection. In case of contact with skin, rinse with plenty of clean water, then cleanse with soap and water. In case of contact with eye, rinse immediately with plenty of clean water and seek medical advice. If swallowed, seek medical attention immediately – do not induce vomiting.
Vetoproof AM764 is non-flammable.
Saveto endeavors to ensure that any advice, recommendations, information it may give, is accurate and correct. It cannot accept any liability either directly or indirectly arising from the use of its products, because it has no direct or continuous control over where or how its products are applied, whether or not in accordance with any advice, specification, recommendation or information given by us. Saveto has the right to change any of the specifications mentioned in the Technical data sheets upon its discretion without prior notification.
Hard copies of TDSs are printed once or twice a year, while our technical data sheets are continuously being updated as per R&D improvements and new 3rd party testing; kindly refer to our website for the latest updated TDSs.
Single component acrylic waterproofing membrane
Single component elastomeric crack-bridging cementitious waterproof membrane
Polymer modified water resistant cementitious top coat
Single component penetrating waterproofing system for concrete
Elastomeric crack-bridging cementitious waterproof membrane
Premixed 5 to 50 mm thick cementitious flowable screed and underlayment.