Manual Applied Premixed Plaster
Plaster Mix M is a cement based plastering material composed of hydraulic binders, selected aggregates, and special additives. It is supplied as a dry powder in pre-weighed bags ready to use on site, which requires only the addition of clean water to produce cohesive mortar. Premix Plaster M is a high quality product contains special shrinkage control additive. It is designed for manual hand application for areas that can not be accessed by machine application. Plaster Mix M is generally applied in thicknesses ranging from 5 to 20 mm per layer.
Plaster Mix M is supplied in 50kg Bag, with coverage: 1.3 - 1.5 Kg / m2 / mm thickness
Original sealed bag of Plaster Mix M has a shelf life of 12 months provided it is stored clear of ground in a dry and shaded place. Plaster Mix M is non-flammable.
For manual mixing add to the mixing container 8-10 litres of water for each 50 Kg bag of Plaster Mix M. Add the powder to the water and mix with a mechanical plaster mixer or low speed electric drill fitted with a suitable paddle for 3-4 minutes, until a uniform, lump-free consistency is achieved.
Hand mixing is allowed for small batch quantities by mixing for approx. 1-2 min or when homogenous mix is achieved. Mixed material must be used within 90 min. Do not add water to the mix once the mixed mortar start to harden.
Plaster Mix M can be applied in a single or two layers on rough or smooth surfaces to achieve the desired thickness. Apply Spatter Dash SB prior to the application of Premix Plaster M.
Apply mixed material using hawk & trowel technique. Rod or level to a uniform thickness of 5-20 mm. When the plaster starts to set follow smoothing the material to achieve the desired appearance.
For thicknesses more than 20 mm, please use practice ASTM C 926: each layer 10 - 15 mm rough finish, should cure before applying the second coat for at least 2 days.
After the surface appears stiff but still moist, follow the smoothing the material to achieve a desired appearance.
Plaster Mix M is best cured by spraying water on the surfaces of applied materials every 12 hrs for minimum of 3 days. During hot & dry conditions allow curing for minimum of 5 days. It will help to obtain high mechanical strengths and minimize the risk of surface cracks.
Substrate should be sound, clean, free from loose material, grease, laitance, dirt, curing compound, etc.
Prior to Plaster Mix M application, damp the entire surfaces with clean potable water. Surface should be suction neutralized at the time of Plaster Mix M application.
Plaster Mix M is highly alkaline therefore avoid direct contact with eyes or skin. It is recommended to use protective gloves and goggles during application. Any skin contact should be wash with soap & water. In case of eyes irritation, immediately wash with copious amount of clean cold water. Seek medical advise.
For further information, please refer to material safety data sheet.
Saveto endeavors to ensure that any advice, recommendations, information it may give, is accurate and correct. It cannot accept any liability either directly or indirectly arising from the use of its products, because it has no direct or continuous control over where or how its products are applied, whether or not in accordance with any advice, specification, recommendation or information given by us. Saveto has the right to change any of the specifications mentioned in the Technical data sheets upon its discretion without prior notification.
Hard copies of TDSs are printed once or twice a year, while our technical data sheets are continuously being updated as per R&D improvements and new 3rd party testing; kindly refer to our website for the latest updated TDSs.
Sprayable premixed plaster
Light weight gypsum perlite plaster
Sprayable Cemenitious Premixed Plastering/Rendering Material
Polymer modified water resistant adhesive for fixing pool, fountain & water tank tiles.