Multipurpose low viscosity bonding agent & admixture
saveto Bond 2 is a single component polymer based, bonding agent for cementitious materials. It is water based, specially formulated to enhance bonding properties as well as improve mechanical strengths of cementitious mixes when incorporated with mixing water. Saveto Bond 2 also reduces shrinkage cracks during early stages of cement hardening by minimizing surface water loss in fresh applied mixes. Saveto Bond 2 can be diluted on site with potable water for desired applications. Saveto Bond 2 is ideal for use with Premix Plaster.
Saveto Bond 2 is supplied in 20 Liter Pail.
Original sealed container of SavetoBond 2 has a shelf life of 12 months provided it is stored clear of ground in a dry shaded place below 25ºC.
Saveto Bond 2 has tendency of soft settlement on storage and therefore it is recommended to mix the material in same container prior to use.
Follow the dilution ratio required for each type of premixed mortar.
Dilute 1 part Saveto Bond 2 with 2 parts water. Mix thoroughly to obtain uniform consistency liquid.
Add the diluted Saveto Bond 2 to pre-blended sand/cement plaster, mortar, or other dry mixes. Mix for 3-4 min using mechanical mixer at low speed. Let the mixture stand for 10 min and mix again briefly to achieve homogeneous lump free mixture.
As Bonding Agent
Dilute 2 parts Saveto Bond 2 with 1 part water. Mix thoroughly to obtain uniform consistency liquid.
Apply using brush or spray directly onto substrate. If using hand pump, spray at a rate of 15 m2/litre. While bonding agent is still wet, follow immediately by applying plaster, render, mortars or joint tapes etc.
Note: Saveto Bond 2 should remain tacky when applying top coat finishes.
Surface must be well cleaned and free from loose materials. Inconsistent parts, varnishes, grease, laitance, algae, must be eliminated through sand blasting or brushing before applying Saveto Bond 2.
Use the whole material once you opened the pack as the material start to skin & then dry.
Do not mix with other materials. Do not apply the product at temperature less than +7ºC.
Tools should be cleaned with water before it hardens. After the hardening its residuals can be removed mechanically only.
For further information contact our technical department.
Saveto Bond 2 is irritant and harmful therefore avoid direct contact with eyes or skin. It is recommended to use protective gloves and goggles during application. In case of contact with eyes, clean immediately with plenty of clean cold water and seek medical advise.
Ensure adequate ventilation when using the material and avoid inhalation of vapours.
Refer to Material Safety Data Sheet for further information.
Saveto endeavors to ensure that any advice, recommendations, information it may give, is accurate and correct. It cannot accept any liability either directly or indirectly arising from the use of its products, because it has no direct or continuous control over where or how its products are applied, whether or not in accordance with any advice, specification, recommendation or information given by us. Saveto has the right to change any of the specifications mentioned in the Technical data sheets upon its discretion without prior notification.
Hard copies of TDSs are printed once or twice a year, while our technical data sheets are continuously being updated as per R&D improvements and new 3rd party testing; kindly refer to our website for the latest updated TDSs.
Multi-purpose bonding agent & admixture
Polymeric soil stabilizer
Polymeric bonding agent, waterproof mix enhancer & primer
Versatile resin adhesive, cement modifier, bonding agent & sealer
Solvent free epoxy bonding agent to bond old to new concrete
Advanced modified cementitious light weight, thermal insulating masonry mortar