Versatile solvent free epoxy based primer
Vetoprime EP390 is a specialty industrial primer for the Vetorep and Vetotop product range, its applied on prepared concrete and cementitious substrates to seal the substrate and enhance bonding with top coats. The product can be used as a stand alone product in internal applications as a seal coat to harden cementitious surfaces and prevent dusting. Vetoprime EP390 is a two component solvent free epoxy resin that has sealing properties making it ideal for concrete, cementitious, and steel substrates
Vetoprime EP390 is supplied in 1 & 4 Liter kits, coverage:7 - 10 m2 /Liter
Original sealed container of Vetoprime EP390 has a shelf life of 12 months provided it is stored clear of ground in a dry shaded place below 35ºC.
- Priming of steel substrates.
Mix Vetoprime EP390 as supplied. Add the entire content of hardener can to the base can and mix thoroughly for about 2 minutes. Once mixed, the Vetoprime EP390 shall be immediately applied in a thin continuous film using stiff brushes or rollers. Avoid over-application and puddles.
Vetoprime EP390 shall be allowed to become tack-free prior to the application of epoxy coating (unless otherwise specified) but well within the open time specified for the given temperature.
The hotter the substrate, the more quickly the primer will become dry.
All tools and equipment shall be cleaned immediately after use with Vetonit Solvent XX400.
It is essential that Vetoprime EP390 is applied to a sound, clean and dry surface in order to achieve maximum bond strength between substrate and coating/repair products.
Should be at least 28 days old and relative humidity of the concrete is 75% or below. Laitance deposits on new concrete are best removed by light grit blasting, mechanical scrabbling or grinding.
Where heavy contamination by oil and grease has occurred or existing coatings are present, it is essential that all contaminations are removed.
Some people are sensitive to epoxy resins; so gloves and a barrier cream shall be used when handling these products. If contact with the resin occurs, it must be removed, before if hardens, with resin removing cream follow by washing with soap and water. Do not use solvent.
During use, avoid inhalation of solvent and contact with skin and eyes. Wear suitable protective clothing, gloves, eye protection and respiratory protective equipment. In case of contact with eye, rinse immediately with plenty of clean water and seek medical advice. If swallowed, seek medical attention immediately – do not induce vomiting.
Vetoprime EP390 is non-flammable.
Refer to Material Safety Data Sheet for further information.
Saveto endeavors to ensure that any advice, recommendations, information it may give, is accurate and correct. It cannot accept any liability either directly or indirectly arising from the use of its products, because it has no direct or continuous control over where or how its products are applied, whether or not in accordance with any advice, specification, recommendation or information given by us. Saveto has the right to change any of the specifications mentioned in the Technical data sheets upon its discretion without prior notification.
Hard copies of TDSs are printed once or twice a year, while our technical data sheets are continuously being updated as per R&D improvements and new 3rd party testing; kindly refer to our website for the latest updated TDSs.
Multipurpose low viscosity bonding agent & admixture
Polymeric soil stabilizer
Polymeric bonding agent, waterproof mix enhancer & primer
Versatile resin adhesive, cement modifier, bonding agent & sealer
Solvent free epoxy bonding agent to bond old to new concrete
Water based mold and form-work release agent