Hydrophilic swellable waterstop
Vetostop SW1 is thermoplastic SEBS based hydrophilic Swellable construction cold joint waterstop. The profile has a Bond-enhancing grooved surface and unique swelling Properties with controlled and delayed expansion.
Vetostop SW1 6 mm *22mm section supplied in 10 m rolls
Vetostop SW1 has an unlimited shelf life provided it is stored clear of ground in a dry and shaded place below 35ºC.
Vetostop SW1 should be used to prevent the passage of water through non-movement joint in both new in-situ concrete and between new and existing concrete. Swelling of Vetostop SW1 in fresh concrete is minimal and most of the volume swell takes place after the initial hardening of the concrete has taken place. Vetostop SW1 waterstop should be positioned to ensure that a minimum of 70 mm cover of concrete is present to accommodate pressure developed during the swelling process. It is recommended that the strip is fixed by both adhesive and mechanical means to ensure maximum contact with the joint faces and to avoid displacement when pouring the fresh concrete.
Instructions to use
Vetostop SW1 may be positioned by bonding using Vetostop XSW adhesive. The waterstop may be installed either into a groove cast in the concrete or directly onto the concrete surface , also Vetostop SW1 can be fastened by using masonry nails at (250-400) mm centers.
Vetostop SW1 is suitable for use in most weather conditions, but heavy rain or prolonged immersion will cause premature swelling. Should this occur, it will be necessary to allow it to dry out, or be dried with a hot air gun before concrete pouring takes place. Vetostop SW1 should not be used in expansion joints, or any concrete section of less than 150 mm width. No welding is required, Splices are formed as butt- joints or simply overlapped.
There are no known hazards associated with Vetostop SW1 during normal use. Refer to product Safety Data Sheet for detailed information.
For further information refer to the Material Safety Data sheet.
Saveto endeavors to ensure that any advice, recommendations, information it may give, is accurate and correct. It cannot accept any liability either directly or indirectly arising from the use of its products, because it has no direct or continuous control over where or how its products are applied, whether or not in accordance with any advice, specification, recommendation or information given by us. Saveto has the right to change any of the specifications mentioned in the Technical data sheets upon its discretion without prior notification.
Hard copies of TDSs are printed once or twice a year, while our technical data sheets are continuously being updated as per R&D improvements and new 3rd party testing; kindly refer to our website for the latest updated TDSs.
Single component acrylic waterproofing membrane
Single component elastomeric crack-bridging cementitious waterproof membrane
Single component flexible pure acrylic waterproofing membrane
Polymer modified water resistant cementitious top coat
Single component penetrating waterproofing system for concrete
Water-Based Chemical & abrasion resistant anti bacterial wall & floor thin epoxy coating